Re: [FWDLK] Wiring Harnesses & Heater Valves

[JLSAVARD@xxxxxxx]

In a message dated 7/15/2003 7:57:27 AM Eastern Standard Time, drt-rdr@xxxxxxxxxxxxxxxx writes:

> BAsically the jist is. unhook and tag every connection, then remove the
> entire harness, lay it out on a 4 x 8 sheet of plywood. then make a template
> by fencing in the harness with nails and string out every wire to it's full
> length. Write on the board what size each wire is and what type of
> connection, then remove the wrapping and take one wire out at a time and
> replace it with a new one.


That's exactly the way that harnesses are built in low production quantities for aerospace.
Joe Savard
Lake Orion, MI