[FWDLK] Misc. Questions

["dirt rider" <drt-rdr@xxxxxxxxxxxxxxxx>]

Hello all, ok who's got the webpages where I can look at the back of some
finned mopars, a buddy and I are brainstorming about adding some fins to a
non forward look car.

Here's another question.
If you were going to a junkyard and wanted to cut off part of a
quarterpanel, like the end fin section with taillight housing.
What would you use to cut it. And you can't use torches or anything
electric. My initial ideas are hacksaw, cordless drill with a cutting wheel
attached to it (not sure if the batteries would hold up to cut it off) one
of those hand held small circular saws with a cutting wheel on it. Drill
some holes in a line down the quater and try and cut it with a good tin
snips. i'm open to any suggestions.

Thanks,
Nick