Yes, the product name is Vigor Circuit Maker. It is available through clock and watch repair supply material houses. I don't think that Radio Shack would know anything about it, but I guess it is worth a try. I am sure that there must be other name brands as well, but I haven't run across them. Using it is still (or at least can be) tricky, but mistakes can be corrected easier, without the potential for heat damage. The key is using as little of the glue as possible but still getting a good strong bond. Too much will effect the movement of the needle. Like anything else, practice makes perfect. Paul In an email dated Tue, 14 12 2004 10:13:00 am GMT, "Mike & Christine Trettin" <mtrettin@xxxxxxxxxxxxxxx> writes: >> Soldering the wires to the needles is a little risky because of the extra >> heat. I use conductive glue. >> >> Paul > >Is there a specific product name you'd recommend, and/or where to buy? ?I >have 3 gage needles that need fixing (for a Chrysler EL dash). > >Thanks, > >Mike Trettin >1956 Imperial Sedan, Turquoise > > > >----------------- ?http://www.imperialclub.com ?----------------- >This message was sent to you by the Imperial Mailing List. Please >reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be >shared with everyone. Private messages (and attachments) for the >Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx >To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm > > ----------------- http://www.imperialclub.com ----------------- This message was sent to you by the Imperial Mailing List. Please reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be shared with everyone. Private messages (and attachments) for the Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm