Re: IML: '59 Trans issue

["jsadowski" <jsadowski@xxxxxxx>]

Have you checked the control buttons to be sure they are in the correct spots? Just a thought before you go to so much trouble. I've taken the tranny out of a 60, minus the bell housing.Rather easy doing it that way, since the cast iron tranny is rather heavy. They do recommend using dowels in 2 of the bolt holes so as not to damage the output shaft. I used 2 bolts with the heads cut off for this purpose.

John

----- Original Message -----

From: Steve B.

To: mailing-list@xxxxxxxxxxxxxxxx

Sent: Sunday, November 21, 2004 5:21 PM

Subject: IML: '59 Trans issue

Ever since my '59 "came back to life" about 5 years ago the trans has
had an issue with staying locked in drive no matter which button is
pushed.  D works fine.  N and the car accelerates forward but only has
first gear and R locks the trans in forward and reverse at the same
time ending up with a car that doesnt move either direction.  I have
always been able to turn the car off and restart and then would have
about five seconds where reverse worked and it only happened on really
hot days after driving the car for a long time.

Now that winter is finally here and I can drive my car again I got in
her and started up for the first time in three months.  Much to the
garage walls suprise the Imperial immediatley ate the sheetrock and
refused to back up at all while the motor was running.  Once I pushed
it out of the garage and drove for a while reverse was functional
again.

I assume this is a failed seal in the trans?  Probably looking at a
total rebuild?

Has anyone here ever tried unbolting the four bolts that hold the
trans to the bell housing and swapping it that way?  Seems like that
would be a heck of a lot easier than chewing up your hands trying to
unbolt the bell housing from the engine and unbolting the torque
converter.  I have an extra trans I pulled from my parts car but I am
debating on whether it would be worth all the effort to swap in an
unknown transmission.   I might be better off to ask Santa for a
transmission kit  :-)

                      Steve B.


-----------------  http://www.imperialclub.com  -----------------
This message was sent to you by the Imperial Mailing List. Please
reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be
shared with everyone. Private messages (and attachments) for the
Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm