Re: IML: Job number "next" - hub / heat

[Imperial48@xxxxxxx]

In a message dated 10/15/04 12:07:16 AM, jsadowski@xxxxxxx writes:


> One reason for not using a lot of heat when trying to separate the hub is that you want to heat the hub only. If the heat transfers to the axle, your fighting a losing battle. Another is that too much heat can cause warping or brittleness.
----------------

Thanks Jerry!


That is exactly why I was trying to avoid heat but I'm afraid that's my only solution.   I'll take my time with it and make sure it heats evenly.   Metal can be forgiving if treated respectfully and that's what I'm going to do!   If you push it too much it's going to let you down.

Thanks for the caring input!   I'll be even more careful!

Ned ????'48 Crown Imperial