Remco; The headers may fit the engine but they may not fit the car, it is even difficult finding a set that will fit in a later C body car. Further headers don't last as long as cast iron because they are made from tube steel which rusts and burns through quicker. If they are stated to fit a Chrysler 300 there is a chance that they might fit, if not I would stay away from them. Besides I am not sure if they would help a propane powered engine that much. Best Regards Arran Foster 1954 Imperial Newport Needing A Left Side Tailight bezel and other trim parts. ----- Original Message ----- From: "r.van.Lent" <remco.nancy@xxxxxxxxxx> To: <mailing-list@xxxxxxxxxxxxxxxx> Sent: Tuesday, August 31, 2004 2:20 PM Subject: IML: headers in a 57 There are some headers for the 392 on ebay will this fit in the 1957 body or is there a problem with the front suspension Remco The Netherlands ----------------- http://www.imperialclub.com ----------------- This message was sent to you by the Imperial Mailing List. Please reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be shared with everyone. Private messages (and attachments) for the Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm ----------------- http://www.imperialclub.com ----------------- This message was sent to you by the Imperial Mailing List. Please reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be shared with everyone. Private messages (and attachments) for the Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm