The problem seems to be the switch, I have incorporated it into a simple circuit . Connected up & with a bulb in the circuit , I pressed the contact down with a match stick & it failed to light up the bulb. Dave. ----- Original Message ----- From: "Dave & Tracy" <dave-tracy.sherratt@xxxxxxxxxxxx> To: <mailing-list@xxxxxxxxxxxxxxxx> Sent: Tuesday, September 07, 2004 7:04 AM Subject: Re: IML: Brake Lights/1960? > The brakes were fully rebuilt just a year ago.This included a new Switch. > all the circuit from the wires at the switch to the bulbs are fine. the bulb > sockets are fine & no corrosion. Today I will pull the switch & check the > contacts inside. Then go from there. > Regards > Dave. > ----- Original Message ----- > From: <RandalPark@xxxxxxx> > To: <mailing-list@xxxxxxxxxxxxxxxx> > Sent: Tuesday, September 07, 2004 1:31 AM > Subject: Re: IML: Brake Lights/1960? > > > > Is this on the '60? If the stop lights work great when you bypass the > switch, then there is something wrong with the switch. In the case of this > car, it could also be that there is something wrong with the hydraulics, or > the switch could be clogged. How is your brake fluid? > > > > Paul > > > > In a message dated 9/6/2004 5:12:10 PM Eastern Daylight Time, "Dave & > Tracy" <dave-tracy.sherratt@xxxxxxxxxxxx> writes: > > > > >when you press the brake pedal the lights will brighten after about 5 to > 10 > > >seconds. I am wondering if the new master cylinder is playing up or > starting > > >too. > > >Dave. > > >----- Original Message ----- > > >From: "Brad Hogg" <roadhogg@xxxxxxx> > > >To: <mailing-list@xxxxxxxxxxxxxxxx> > > >Sent: Monday, September 06, 2004 9:01 PM > > >Subject: Re: IML: Brake Lights > > > > > > > > >> If when you revv the engine and the lights get brighter, that indicates > a > > >> poor battery. > > >> > > >> > > >> Please quote this message in your reply. Otherwise I will be unable to > > >> reply to your message. Thanks. > > >> > > >> > > >> > > >> ----- Original Message ----- > > >> From: "Dave & Tracy" <dave-tracy.sherratt@xxxxxxxxxxxx> > > >> To: <mailing-list@xxxxxxxxxxxxxxxx> > > >> Sent: Monday, September 06, 2004 2:48 PM > > >> Subject: IML: Brake Lights > > >> > > >> > > >> What will cause poor brake lights apart from a bad ground . Mine seem > to > > >be > > >> sometimes working , but dull. However when you rev the engine they go > > >bright > > >> ! The switch is a new one, & the wires when touched together light the > > >> lights great. would the wires crossed to the switch over give this > effect > > >? > > >> Regards > > >> Dave. > > >> > > >> > > >> > > >> ----------------- http://www.imperialclub.com ----------------- > > >> This message was sent to you by the Imperial Mailing List. Please > > >> reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be > > >> shared with everyone. Private messages (and attachments) for the > > >> Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx > > >> To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm > > >> > > > > > > > > > > > >----------------- http://www.imperialclub.com ----------------- > > >This message was sent to you by the Imperial Mailing List. Please > > >reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be > > >shared with everyone. Private messages (and attachments) for the > > >Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx > > >To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm > > > > > > > > > >