Removal of incorrect wiper arms from '64
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Removal of incorrect wiper arms from '64



I'd start by spraying WD-40 or similar around the mounts.Then, try lifting the arm up away from the glass a bit so it is about level with the mount point. While holding level, try to lift it from the mount.
John
----- Original Message -----
From: Dave Grove
Sent: Sunday, August 01, 2004 6:33 PM
Subject: Re: IML: Removal of incorrect wiper arms from '64

Ed, - I do not think that tool is still available.  I have been trying to
find one for a long time.  There are many "wiper tools" on the market, - but
none of them really work, - not like that one anyway.  Very simple, and
always worked, - and no chance of damage to the car's finish.  The stuff you
can get now is akward to use, and some of them will even mar the paint if
you are not really careful.
Most of them won't even "hold" the arm, - so it lands on your hood when it
"pops" off.

Give me the old stuff........

Regards,
DaveG.
----- Original Message -----
From: "Edward Trenn" <imperial64@xxxxxxx>
To: <mailing-list@xxxxxxxxxxxxxxxx>
Sent: Sunday, August 01, 2004 9:17 PM
Subject: IML: Removal of incorrect wiper arms from '64


> Folks,
> I have an incorrect set of wiper arms on my '64; they are supposed to
> screw in with a chrome bolt, but instead are similar to '66 and later
> which have a solid piece with NO bolt. How do I remove the arm? The '66
> service manual shows a special tool that looks a bit like a wrench. Is
> that tool still available?
>
> I'm assuming that they were stuck onto the original posts, but any any
> advice is appreciated.
>
> Thanks!
>
> Ed Trenn
> '64 Crown Coupe
> '64 Crown convertible
>
>
>
> -----------------  http://www.imperialclub.com  -----------------
> This message was sent to you by the Imperial Mailing List. Please
> reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be
> shared with everyone. Private messages (and attachments) for the
> Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
> To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm
>




-----------------  http://www.imperialclub.com  -----------------
This message was sent to you by the Imperial Mailing List. Please
reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be
shared with everyone. Private messages (and attachments) for the
Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm


Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.