80s belt/alt
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

80s belt/alt



Thanks everybody,

I figured it had to be a 100 amp, but you can never be TOO sure. I put a 
Magnum crate motor in it. The thermostat housing is offset to the wrong 
(right) side, so I had to remove the a/c compressor.  Now I'll spend the 
summer pulling the accessories and brackets off a dakota and trying to hook 
it all up or (more likely) I'll just sweat.

On the bright side, I have a 300+ hp new engine and I have my old 360 to 
rebuild and drop into one of my projects.

Rob


>From: "David Utecht" <stealthloader@xxxxxxxxxxx>
>Reply-To: mailing-list@xxxxxxxxxxxxxxxx
>To: <mailing-list@xxxxxxxxxxxxxxxx>
>Subject: RE: IML: 80s belt/alt Date: Fri, 27 Feb 2004 09:20:48 -0500
>
>Rob,
>
>   All 81-83 Imperials came with a 100amp alternator as standard equipment.
>As for the belt length take a piece of string and run it around the 
>pulleys,
>then measure the length.  This is not an exact science but it will give you
>a place to start. By the way what intake manifold did you use?  I used an
>Edelbrock Performer on my 360 and everything bolted right up.
>
>Dave U.
>81 Imp
>
>-----Original Message-----
>From: mailing-list-owner@xxxxxxxxxxxxxxxx
>[mailto:mailing-list-owner@xxxxxxxxxxxxxxxx]On Behalf Of Rob P
>Sent: Friday, February 27, 2004 12:01 AM
>To: mailing-list@xxxxxxxxxxxxxxxx
>Subject: IML: 80s belt/alt
>
>Does anybody know if my '83 would likely have a 100 amp alternator?  I
>assumed they'd all be the same, since there were no options, but the NAPA
>site indicates at least 2 alternators. I have to disconnect my a/c and 
>leave
>the compressor off because it interferes with my new intake.  I figured I
>could get the belt from a Cordoba/Mirada with no a/c, since my belt will no
>longer be going around the a/c pulley.  Problem is that the NAPA site
>indicates different part numbers for 100 amp and non-100 amp alternators.
>Worse, it indicates that the belt is the same for a 100 amp with or without
>a/c! That can't be right. The belt would have to be considerably shorter.
>
>Any ideas appreciated. Yes, I have the FSM, unfortunately they are with my
>mechanic.  He could take care of all this, but he's been doing me a favor
>and I'm trying to make the job go faster and easier (cheaper).
>
>Thanks.
>Rob
>
>_________________________________________________________________
>Take off on a romantic weekend or a family adventure to these great U.S.
>locations. http://special.msn.com/local/hotdestinations.armx
>
>
>


Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.