Using a Dodge 1/2 ton truck rear end in a 67 Imperial. Is This Po ssible?

["Bar00n" <baroon@xxxxxxxxxxxxx>]

You also want to make sure the springs are the same width as the Imperial
width.

If the truck has a plate bolted on the back of the diff, then it's not an
8.75 rearend which might be a pain in the arse for you too. With any luck
you'll get the 'regular' axles out of the truck and they are 5 on 4.5"
instead of the rare 5 on 5 pattern.

Good luck

----- Original Message -----
From: "Tristan Moore" <v-2tmoor@xxxxxxxxxxxxxxxxxxxxxxx>

Does anyone know the width of the rear end in a 67 Imperial? I'm thinking of
using one out of a dodge pickup truck.