Re: IML: Converting to electronic ignition

[PAUL WENTINK <randalpark@xxxxxxx>]

If it ran fine before, the ignition timing may be off. Just a guess.

Paul W.


-----Original Message-----
From: Nick Conti <nickjconti@xxxxxxxxxxxxx>
To: mailing-list@xxxxxxxxxxxxxxxx
Sent: Tue, 30 Oct 2007 2:23 pm
Subject: IML: Converting to electronic ignition



I purchased a conversion from Pertronix to convert my 66 Crown to 
electronic ignition.  After installation the car refused to start.  
Tech help told me to bypass the resistor on the firewall which I did.  
The car will start but runs very rough and stalls if you remove you 
foot from the gas.  Any help would be greatly appreciated.

Thanks in advance

Nick J. Conti


________________________________________________________________________
Email and AIM finally together. You've gotta check out free AOL Mail! - 
http://mail.aol.com

-----------------  http://www.imperialclub.com  -----------------
This message was sent to you by the Imperial Mailing List. Please
reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be
shared with everyone. Private messages (and attachments) for the
Administrators should be sent to iml.webmonster@xxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm