Re: IML: 62 Alternator not charging
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: IML: 62 Alternator not charging
- From: randalpark@xxxxxxx
- Date: Mon, 24 Sep 2007 19:57:38 -0400
Normally, I would completely agree here, but my recollection of the
original post was that virtually everything had already been replaced
except the alternator. Usually in a no charge situation, I check all of
my connections, then test the alternator. If it checks out, I don't
mind replacing the regulator since I can keep the old one as a spare if
its good.
The two main reasons I have encountered this problem have been dirty
connections or a failed alternator. I have never had a regulator go bad
as far as I know.
Paul W.
-----Original Message-----
From: Geoff Fors <wb6nvh@xxxxxxxx>
To: mailing-list@xxxxxxxxxxxxxxxx
Sent: Mon, 24 Sep 2007 10:55 am
Subject: IML: 62 Alternator not charging
I suggest testing the components to avoid wasting money replacing things
which are still good.
There is a simple procedure shown in any Motor's Manual of the era which
will show you how to use a jumper wire to test the alternator. By
jumpering
it, you put the alternator into the full charge mode and bypass the
regulator. If there's no output at that point, you can assume it's the
alternator/generator and not the regulator. By following the test
process
you won't replace any components which are still good. I would explain
the
test here but there are quite a few different setups out there and I
can't
remember off the top of my head what the alternator and regulator look
like
on the early ones.
In this case it could be the brushes have worn out on the alternator,
or the
regulator has gone bad. The big stud on the alternator with the big
wire
should register charging voltage when the engine is running, and battery
voltage when off.
The small part you mention is an oil filled paper bypass capacitor
which is
used to suppress alternator noise in the radio. You will probably have
to
put that on a new alternator (if you indeed need one at all.) I also
replaced my regulator with a transistorized version, as I found the
contacts
inside the stock ones create radio static on weak stations, and this
also
brought the charge level to a more even rate.
Geoff
Monterey CA
----------------- http://www.imperialclub.com -----------------
This message was sent to you by the Imperial Mailing List. Please
reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be
shared with everyone. Private messages (and attachments) for the
Administrators should be sent to iml.webmonster@xxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm
________________________________________________________________________
Email and AIM finally together. You've gotta check out free AOL Mail! -
http://mail.aol.com
----------------- http://www.imperialclub.com -----------------
This message was sent to you by the Imperial Mailing List. Please
reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be
shared with everyone. Private messages (and attachments) for the
Administrators should be sent to iml.webmonster@xxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm
Back to the Home of the Forward Look Network