IML: Turn Signal Indexing
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

IML: Turn Signal Indexing



Rob;

I think you are on the right track. I looked at the section of the '62 service manual that talks about power steering gear replacement. After the steering wheel and turn signal switch etc. plus the lower steering wheel column trim cover has been removed, it talks about removing the retainer snap ring from the groove in the steering tube at the top of the bearing. Then it says to remove the jacket tube shield to allow access to the column tube clamp and remove the screws attaching the steering jacket tube clamp at the instrument panel and remove the clamp. It mentions that there is an inspection panel on Imperials. I think this may be under the carpet. Unfortunately there is not a complete assembly drawing or picture of the procedure they describe. It does not show how to line up the parts for reassembly. It sounds like a good candidate for a set of digital pictures for posterity.

Joe
begin:vcard
fn:Joe Strickland
n:Strickland;Joe
adr;dom:;;1021 Vaughan Lane;Tioga;TX;76271
version:2.1
end:vcard



Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.