RE: IML: 56 Ignition Problem - Pertronix
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: IML: 56 Ignition Problem - Pertronix



thanx. i have purchased the pertonix. going to install this spring. glad that it works wonderful

Ken Lang <imperialken@xxxxxxxxx> wrote:
I too, am using the Pertronix ignition module on both my Imperials.  I have nothing but good things to say about it.  Granted, it is not 100% original under the hood but the only way to tell is by removing the distributor cap.  Otherwise there is nothing visibly different.  Plus I now have the piece-of-mind knowing that the car starts first time every time.
 
For anyone having ignition problems, I can?t recommend it enough.  (and it works with or without a ballast resistor)
 
Ken
67 Crown 4 Dr Ht (Pertronix equipped)
68 LeBaron 4 Dr Ht (Pertronix equipped)
 
 

From: mailing-list-owner@xxxxxxxxxxxxxxxx [mailto:mailing-list-owner@xxxxxxxxxxxxxxxx] On Behalf Of Frederick Joslin
Sent: Thursday, February 08, 2007 9:20 AM
To: mailing-list@xxxxxxxxxxxxxxxx
Subject: Re: IML: 56 Ignition Problem
 
I have been following this thread on and off.
I had a 1966 Newport that died one morning.
I went through all sort of trouble shooting and it ended up being a bad voltage regulator.
 
The good part of this story is that I replaced everything in the ignition and the voltage regulator with modern stuff. I used the opportunity to install a Pertronix I electronic ignition.
The car ran flawlessly for another ten years without a tune up after this!
 
----- Original Message -----
From: "Brad Weikert"
To: mailing-list@xxxxxxxxxxxxxxxx
Subject: Re: IML: 56 Ignition Problem
Date: Wed, 7 Feb 2007 21:47:15 -0700


Well I certainly hope that fixes it for you.
Strange that the coil would be fried, a bad
condenser should not damage the coil. A good
coil will act like it's bad if the condenser is
not working but will work fine again once the
condenser is replaced.

Have a good evening
Brad


On Feb 7, 2007, at 9:09 PM, Jeff Cantor wrote:

> Brad,
>
> Your explanation made very good sense! As a
> mechanical engineer, I always forget to use
> the water analogy when dealing with
> electricity.
>
> Now I think can feel pretty safe in saying
> that my problem is probably the condenser
> (and the now fried coil).
>
> Jeff
> 56 Sedan
> Trenton, NJ



----------------- http://www.imperialclub.com -----------------
This message was sent to you by the Imperial
Mailing List. Please reply to
mailing-list@xxxxxxxxxxxxxxxx and your response
will be shared with everyone. Private messages
(and attachments) for the
Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm
 
Fred Joslin
 



 


Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.