Re: IML: electroluminescent lighting power supply
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: IML: electroluminescent lighting power supply



One light can suddenly short out and that is exactly what would happen. Poof! the system would go dark. I wouldn't write off the power supply until checking for shorts in the system. The power supply isn't usually the problem. It can be and so can the headlight switch, but usually not.

One thing to note is that the power supply is mounted in a spot where a leaky windshield gasket can ruin it. If the power supply is rusty looking I'd check for leaks before replacing it.

Paul W.

-----Original Message-----
From: R.vdes@xxxxxxxxxxxxxxx
To: mailing-list@xxxxxxxxxxxxxxxx
Sent: Tue, 6 Feb 2007 7:17 AM
Subject: Re: IML: electroluminescent lighting power supply

Hi Dave,

Well, ofcourse you can check for shorts but if you have a short then the whole EL system would be dark and it won't have worked for a few months.

However, you can easily check the entire system for shorts by pulling the white wire that is going to an Electroluminescent item one by one. If the system then suddenly lights up you have found the wrong part of the system.

On the otherhand, the power supply maybe at fault. But first make sure it is properly grounded and that it is receiving 12 V battery power. Unplug it from the wiring that is going to the dash, give it 12V and check for an AC output of approx. 250V.

If not, it is time for rebuilding it. This shouldn't be too difficult as long as the transformer is allright. You will find all the info you need on the IML site (repair section).

Good luck,

Robert
1960 4 door HT Crown
----- Original Message -----
From: David Dimitriou
To: mailing-list@xxxxxxxxxxxxxxxx
Sent: Tuesday, February 06, 2007 3:35 PM
Subject: IML: electroluminescent lighting power supply


I found the write up on the web site. I was actually able to repair my push button electroluminescent panel and the wiper dial using the technique detailed in the write up. Worked great! However recently my power supply just up and died. Everything worked great for a few months and then poof. So now it looks like I'll need to repair the pwr supply.

My question is could I have done something wrong during my repairs that would have caused the power supply to die? I'd hate to get my power supply repaired only to kill it again because my system had problems. What should I check for to ensure this does not happen again? I figure testing for shorts would be a good idea. Any other suggestions?

Thanks,
Dave

No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.5.411 / Virus Database: 268.17.19/663 - Release Date: 1-2-2007
________________________________________________________________________
Check out the new AOL. Most comprehensive set of free safety and security tools, free access to millions of high-quality videos from across the web, free AOL Mail and more.



-----------------  http://www.imperialclub.com  -----------------
This message was sent to you by the Imperial Mailing List. Please reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be shared with everyone. Private messages (and attachments) for the
Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm



Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.