----- Original Message -----
Sent: Thursday, October 12, 2006 1:48
PM
Subject: Re: IML: Seat belts-1960
Dear Donn,
I have a '60 LeBaron with factory belts and using those patterns I am
about to drill the holes in my '60 Crown. The outside belts were bolted
to body mount bolts and I have measurements for the inner. Of course the
Lebaron had only two pair on the front seat so the back is a guess. They
say Chrysler and I am sure they are original to the car. I'll try to get
you the info./pictures out this weekend.
Richard Burgess
'60 Crown
Donn Reese <DReese@xxxxxxxx>
wrote:
My
car didn't come with seat belts. I bought a set from Bob H.....but how do
you install them?
I haven't found a picture or installation
discussion in any of the publications. They obviously need to bolt through
the floorpan, and it seems the nut should go on the bottom side. Assuming
there is a nut as I only received the bolts. My big problem is locating
where to bolt them down. Could someone with a similar year Imperial share a
couple pictures of where their seat belts are bolted down? Under the back
seat would be great too. Email me off list.
Does anyone know if there
is a knock-out in the floor pan for the bolts or do I need to drill
holes?
Thanks,
Donn Reese
1960 Custom 4dr
HDTP
----------------- http://www.imperialclub.com
-----------------
This message was sent to you by the Imperial Mailing
List. Please
reply to mailing-list@xxxxxxxxxxxxxxxx and your response
will be
shared with everyone. Private messages (and attachments) for
the
Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
To
UN-SUBSCRIBE, go to
http://imperialclub.com/unsubscribe.htm
Yahoo! Messenger with Voice. Make
PC-to-Phone Calls to the US (and 30+ countries) for 2¢/min or less.