Re: IML: ambient air temp. sensor

["J & C" <jchudd@xxxxxxxxxxx>]

I found it...Just have to find a repalcement now... Thanks..

----- Original Message -----

From: alan1416@xxxxxxx

To: mailing-list@xxxxxxxxxxxxxxxx

Sent: Saturday, September 30, 2006 2:47 PM

Subject: Re: IML: ambient air temp. sensor

It is back of the grill, driver side center. mounted under the top frame. This is the frame the hood latches to.  The grill come out very EZ. it is help in place with 2 phillips head screws at the top left and right. The wiring to looks to run up the center support, this is the one the head lamp door motor is mounted to. so follow it and it will end at the NODE.

I can scan the pg and send if that will help you

--
Alan Jordan

-------------- Original message from "J & C" <jchudd@xxxxxxxxxxx>: --------------

Alan I just need to find where this NODE is located. I have a doner 90 Imperial with the electronic option that I can try to find it on. Thanks Jeff

----- Original Message -----

From: alan1416@xxxxxxx

To: mailing-list@xxxxxxxxxxxxxxxx

Sent: Saturday, September 30, 2006 10:59 AM

Subject: Re: IML: ambient air temp. sensor

Jeff   I reread my last E-mail, so as not to freak ya out this Engine Compartment NODE is just for the EVIC. It has nothing to do with the motor, or the fuel systems on the car. It just gives inputs to the EVIC Overhead display In the IMPs and 5th AVE is they have the digital dash and the EVIC.

--
Alan Jordan
90 IMP
75 LeBaron

75 LeBaron Crown Coupe

-------------- Original message from alan1416@xxxxxxx: --------------

Hi Jeff

 

From the FSM said the Temp is supplied to the EVIC (overhead display) by the Engine Compartment NODE. This NODE thing-E is up front and behind the grill. It look like any other black box module. The FSM said to look at a 4th FSM I don't have called the   1990 AC, AY Body Diagnostic Test Procedure Manual.

 

Has any one out there seen or have a copy of this book?

 

--
Alan Jordan
90 IMP
75 LeBaron

75 LeBaron Crown Coupe

-------------- Original message from "J & C" <jchudd@xxxxxxxxxxx>: --------------

Ken,

 

I'll check it out. I have found what looked like sensor in front of the radiator towards the driverside. I changed it with another sensor from a boneyard donor car and it still reads way high...Thanks for the info... Jeff

----- Original Message -----

From: Ken Lang

To: mailing-list@xxxxxxxxxxxxxxxx

Sent: Friday, September 29, 2006 1:47 PM

Subject: RE: IML: ambient air temp. sensor

Jeff,

 

Not sure about the 90 Imperial, but the other Mopar cars I own have the sensor in front of the radiator and off to one side out of direct wind.

 

Ken

67 Crown 4 Dt Ht

 

 

---

From: mailing-list-owner@xxxxxxxxxxxxxxxx [mailto:mailing-list-owner@xxxxxxxxxxxxxxxx] On Behalf Of J & C
Sent: Friday, September 29, 2006 3:12 PM
To: mailing-list@xxxxxxxxxxxxxxxx
Subject: IML: ambient air temp. sensor

 

Hi all,

I have a question regarding the location of the ambient temperature 

sensor that my 1990 Imperial uses for the overhead display console.
Right now it always reads around 130 which I think is a default 
number for a bad sensor. I do not know the location of this sensor so 
that I can change it and get an accurate outside temp. Thanks...Jeff

1990 Imp.
1991 Imp.