IML: 1958 temp gauge removal

[rex crews <rexcrews@xxxxxxxxxxxxx>]

Hello Group,

I am attempting to replace the temperature gauge in my '58 Crown and 
cannot decide the best way to go about it.  It is almost impossible to 
reach from the back nor can I see any way to pull the entire cluster 
forward.  I considered removing the dash but that looks hard as well. 
Has anyone performed this job who can email me off-list with how he did 
it?  I would like to go the easiest route for my back and without 
tearing up more than I have to.  Any suggestions would be most 
appreciated.

Rex Crews  1958 and 1960 Crowns



-----------------  http://www.imperialclub.com  -----------------
This message was sent to you by the Imperial Mailing List. Please 
reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be 
shared with everyone. Private messages (and attachments) for the
Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm