IML: Headlights
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

IML: Headlights



About the blinding headlights thread on the list, improper aiming is one of the leading causes of glare from US spec headlamps. Being that the US government mandated a fuzzy beam pattern for US lamp manufacturers in years past, these lamps were notoriously difficult to properly aim, as well as providing minimal lighting. The European standard, known as E-Code beam pattern, has a sharp cutoff of the light beam that is dipped for oncoming traffic, and specific aiming points for proper aiming. Many US States have specific codes which allows for such types of improved lighting equipment.
As I understand it from the material I've come across on the subject, halogen sealed beam lamps actually provide slightly less light than the sealed beams that came originally in our cars. The whiter light is what helps the recognition of the roadway being lit.
Obligatory Imperial content: If one were to use replaceable bulb lamp units, ie non sealed beams, and were to up the wattage of the bulbs, this would put a larger electrical load on those Imperials with the previously mentioned rocker style headlamp switch if a relay isn't utilized in the system, increasing the likelihood of eventual switch failure.
A preferred lighting upgrade would include a relay installed into the system and an upgrade of the headlamp to a more efficient design, such as Cibie's Complex Reflector style of lamp, so that a standard wattage bulb can be used while increasing the effective light on the road.
Now to some headlamp basics: To get the light from the bulb to the road, the typical process of the old style of headlamp is to reflect the bulb's output off of an unsophisticated, flat surfaced reflector bowl, then through a highly bevelled glass lens which shapes the pattern of the beam. The flat surfaced reflector bowl has some inefficiencies in that is has cold spots and hot spots based on the characterists of the bulb's filament shape, with no means to capitalize on the hot spots. As well, relying on a highly bevelled glass lens to shape the beam pattern produces inefficiencies of it's own.
The Cibie' CR lamps have a reflector backing that is shaped/bevelled to make maximum use of the bulb's filament's hot spots of output specific to the bulb's placement in the lamp bucket. Being that the beam pattern shaping is now done by the complex design of the reflector backing instead of relying on a highly bevelled clear glass lens, there is greater efficiency of light travel through it's relatively simpler lens.


Ok, thats probably more than anyone wanted to know, but when I read of people upping bulb wattage, I can't seem to restrain myself. For those interested, more on these lamps can be read here http://dsl.torque.net/products/csr.html I have a set, they provide a more even light dispersion as well as more light when compared side by side to a replaceable bulb E-Code lamp bucket from Hella with matching bulbs. I run standard wattage bulbs and never get any high beam flashing from oncoming motorists as they are aimed properly.

Eric
'63 Crown Four-Door
'72 Newport Custom sedan




----------------- http://www.imperialclub.com -----------------
This message was sent to you by the Imperial Mailing List. Please reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be shared with everyone. Private messages (and attachments) for the
Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm




Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.