413 and 440 Distributor Question
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

413 and 440 Distributor Question



I presume that even if there is a physical fit you need to get the right vacuum 
advance curve and so on to match the engine/cam combination?

Regards

Ian
 
On Tuesday, August 03, 2004, at 01:21PM, Plymouth Fury <vexnerfinfan@xxxxxxxxx> 
wrote:

>
><<Original Attached>>


-- 

Ian Beeby
Hello Fellow Imperialists,
 
Does anyone know if a 440 electronic distributor will fit into the 413?    Both engines are RB, or raised block, so I know the length should be the same....but my main concern is if the distributor housing will fit the block opening and seal properly.    Long story short, I want to convert my 1960 Crown 413 over to a brand new electronic 440 conversion.   I've absolutely had it with points and worn out old distributor bearings.  
 
I just wanted to make sure it will fit before I order one of these kits, so I'm consulting you pros first.
 
Thank you!!
Chris
 
60 Crown 4dr Sedan
59 Crown 4dr HT
 


Do you Yahoo!?
New and Improved Yahoo! Mail - 100MB free storage!

Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.