Stainless Steel Finishing

["Don Nonnweiler" <dnonnwei@xxxxxxxxx>]

I screwed up replied to the wrong email
----- Original Message -----
From: "Don Nonnweiler" <dnonnwei@xxxxxxxxx>
To: <mailing-list@xxxxxxxxxxxxxxxx>
Sent: Tuesday, December 17, 2002 7:31 AM
Subject: Re: IML: Stainless Steel Finishing


> Sometimes I'm out in the garage, but I'll come into the house around 3PM
so
> I don't miss your call.  I know it might seem out of the way but if you
just
> come by it might be easier, hope I'm not getting too anal
> Don
> ----- Original Message -----
> From: <pbrust@xxxxxxxxxxxxxxxxxx>
> To: <mailing-list@xxxxxxxxxxxxxxxx>
> Sent: Tuesday, December 17, 2002 7:13 AM
> Subject: IML: Stainless Steel Finishing
>
>
> > The "brush finish" on stainless steel is simply controlled scratching.
3M
> makes a white pad specifically for this purpose...I have one somewhere if
> anyone needs some. Any commercial kitchen equipment dealer should have the
> pads.
> >
> > Phil Brust
> > Jefferson GA
> > 73 & 82 Imperial
> >
> >
> >
> >
> >
> >
> >
> >
> >