Need help on 81-83 EFI
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Need help on 81-83 EFI



Stan -
With an ohmeter, measure the resistance of the Water Temperature Sensor
located near the water outlet -there are two terminals in a "Vee"
arrangement. The resistance should be no more than 950 when cold, 1200 to
1500 when warm. Also, for this car with this mileage, remove and replace the
Pick-Up Coil in the Distributer; don't bother checking it, just throw it
away. This is a most annoying problem and we all tend to blame the injection
system for this stalling, sagging, problem. A can of Fuel Injector Cleaner
or gas treatment may help purge the system of old gasoline. Bob Harris
----- Original Message -----
From: <Stan5907@xxxxxxx>
To: <mailing-list@xxxxxxxxxxxxxxxx>
Sent: Tuesday, April 09, 2002 7:35 PM
Subject: IML: Need help on 81-83 EFI


>
> OK now my problem the car start right up but when you start out to drive
her
> she will not take the gas unless you give it to her very slowly.  Then
when
> she gets hot I cannot get it over 20 mph till she just quits.  Starts
right
> back up and OK for about 1 mile or so then same problem again.




Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.