RE: IML: cracked block repair
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: IML: cracked block repair



We have a person in Southwest Portland, Oregon, Jim Classen, who has been repairing cracked blocks for years. He does the drilling method as explained below. He is the only one in the Northwest to go to. He has rebuilt almost all of the “Packard engines” in show cars in our area and other classic engines such as Maxwell. He has been working out of his home for many years and still going strong  in his late 70’s.

 

This method is worth the money if you have a rare engine.

 

John Chesnutt, Portland, OR

 

From: mailing-list-owner@xxxxxxxxxxxxxxxx [mailto:mailing-list-owner@xxxxxxxxxxxxxxxx] On Behalf Of gkitterma@xxxxxxx
Sent: Friday, February 08, 2008 6:31 AM
To: mailing-list@xxxxxxxxxxxxxxxx
Subject: Re: IML: cracked block

 

Bill's information is right on. Be sure to read his wording carefully regarding stop drilling just beyond the end of the crack. This is standard aircraft practice as well. There are thousands of commercial and private aircraft in service, some with hundreds of stop drilled fatigue cracks, flying safely around the world.

Gary Kitterman
'56 C-73 "Babe"

-----Original Message-----
From: William Miller <abmiller@xxxxxxxxxxxx>
To: mailing-list@xxxxxxxxxxxxxxxx
Sent: Fri, 8 Feb 2008 12:23 am
Subject: IML: cracked block

Greetings All,

Cracks in cast iron can be repaired if there is enough thickness.  There is a business on line with a good web site.

Metal Locking Service Inc.  1-866.Fix Iron

Their fix is similar to what we did back in the 50's to repair cracks.  It worked for cracks in flathead valve seats.  Fix the crack, cut out for a replacement valve seat and grind for the correct angle, put it back together.

We would drill an 1/8" hole just behind the end of the crack, in good metal.  Then start drilling holes down the crack. Into each hole we drove a tapered steel pin coated with Litharge (PbO) and Glycerin.  Each hole drilled clipped the previous one, so there was a solid line of pins.  The above business taps each hole and screws  a pin into the hole.

The above fix was labor intensive but could rescue a block that could not be replaced.

Darn, I sound old when I bring something like this up.

 

Bill Miller

68 Crown 4dr HT

64 300K conv.


More new features than ever. Check out the new AOL Mail!



Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.