Re: IML: Wheel center bore importance
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: IML: Wheel center bore importance



> From: "Daniel Richardson" <TheRichardsonFamily@xxxxxxxxxxx>
> Subject: IML: Wheel center bore importance
>
> Another wheel question:
>
> My '65 has a wheel center bore diameter of 2&1/8".  I am thinking of
> buying new wheels that have a center bore of 3.3".
>
> Too small of a hole would be a problem, obviously - is there
> any issue with having a larger hole on the wheels than
> 2&1/8"?  Does the center bore offer any type of support
> to the wheel - or is all the structural integrity in the
> lug nuts?
>
> Any advice would be appreciated.

I've seen a lot of cars with oversized center-hole wheels on them, some from the factory. It doesn't seem to cause problems.

I'd say, if you're at all nervous, you could put new lugs in, and leave it at that.
    -Kle.
    '69 Crown 4DHT (resting)

-----------------  http://www.imperialclub.com  -----------------
This message was sent to you by the Imperial Mailing List. Please reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be shared with everyone. Private messages (and attachments) for the
Administrators should be sent to iml.webmonster@xxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm



Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.