In the service manual for the '62 models it says "Double tubing should always be used to insure long life and corrosion resistance." Does anyone know just what "Double Tubing" means? I measured the OD of the existing OEM tubing and it appears to be about 0.195 to 2.00 inches. Perhaps they mean double clad or double plated (inside and out) tubing? Or do they mean double wall tubing? It is close to time to replace the brake lines as I work on restoring the brake system. Thanks. Joseph W. Strickland 1021 Vaughan Lane Tioga, TX 76271-2937 ________________________________________ PeoplePC Online A better way to Internet http://www.peoplepc.com ----------------- http://www.imperialclub.com ----------------- This message was sent to you by the Imperial Mailing List. Please reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be shared with everyone. Private messages (and attachments) for the Administrators should be sent to iml.webmonster@xxxxxxxxx To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm