Re: IML: iml 60 brake light switch/fuse?/also...

["Steve B." <Imperial59@xxxxxxxxxxxxxxx>]

> i checked the feed at the m/c and found power, umm.. direct wired the b/l 
> wire but still no >brake lights ? i checked the bulbs and found ok ! - had 
> another look at fuse board ,but nowt >found.

If you have power at the master cylinder then you can leave the fuses be.... 
The m/s is down line from the fuse block.

> surley there must be a relay or fuse box for the elec windows and 
> head/tail/brake lights ???

High draw devices use circuit breakers tht reset themselves.  Brake lights 
are not a high draw item.

Turn signals are working?  If they are working then the next place I would 
suspect would be the turn signal switch.

> re m/c - found that brake fluid is leaking from top of m/c when brakes 
> applied ? air in system ?

There should be a piece between the lid and master cylinder that acts as a 
gasket.  It is the size of the lid and has a hole in the middle for the bolt 
to go through.

            Steve



-----------------  http://www.imperialclub.com  -----------------
This message was sent to you by the Imperial Mailing List. Please 
reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be 
shared with everyone. Private messages (and attachments) for the
Administrators should be sent to iml.webmonster@xxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm