Hi,Rich. I believe, all engines (Chrysler) ,had a road vent tube, for crankcase venting untill 62-63 when CAP ( Clean Air Package) was started, then pcv valves took over. I also think there was a mesh type material in the baffle area for oil slosh, a crude filter. If the baffles were cut out, it's possibile they were removed, because the were plugged-up. You could convert to pcv, by drilling carb base, there was a boss in primary side,and secondary sides of most AFB's The baffle must cover the port by a few inches, or you can suck oil out, when running at high rpms. Hope this helps, Dave.-------------- Original message --------------
From: richard burgess <lecrown60@xxxxxxxxx>
Hello Folks,I have the valve covers from two different 1960 Imperials and both have had large sections of the interior baffles cut out. Both cars were very original so I find it surprising that either would have been modified outside the factory. Now I have found another and the baffles in it are not cut out. Was there some service buletin that recommended doing this?Richard Burgess'60 Crown sedan
Yahoo! Messenger with Voice. Make PC-to-Phone Calls to the US (and 30+ countries) for 2¢/min or less.
Stay in the know. Pulse on the new Yahoo.com. Check it out.
- References:
- Re: IML: '60 413 valve covers question
- From: sosmi
- Prev by Date: IML: Windshield
- Next by Date: Re: IML: '60 413 valve covers question
- Previous by thread: Re: IML: '60 413 valve covers question
- Next by thread: Re: IML: '60 413 valve covers question
- Index(es):
Back to the Home of the Forward Look Network