Re: IML: flitesweep reflectors
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: IML: flitesweep reflectors



Someone send me a jpg or two of what this thing looks like in detail, especially the back side. It almost seems that a good alternative would either be a resin type part that was vacuum metallized - similar to what Mr.G's does - or perhaps lost wax method of casting out of metal, if the original was pot metal that certainly doesnt have a extremely high melting point.

If I could see the thing it would be most helpful to determine how to make a replacement, since obviously Chrysler probably had them cast or stamped by the thousands for cheap and we dont have the tooling anymore.

Many thanks

Mikey
62 Crown Coupe

-----------------  http://www.imperialclub.com  -----------------
This message was sent to you by the Imperial Mailing List. Please reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be shared with everyone. Private messages (and attachments) for the
Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm



Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.