IML: Brake lights not working on a 74

[Zack Morton <zmorty74@xxxxxxx>]

Thank you so much for all your suggestions.  The turn signals do  
work.  As well as hazards, and everything else on that fuse.  There  
are 4 wires going into the brake light switch.  Two from the cruise  
control?  I tried bypassing them both, to no avail.  Is it worth  
getting a new switch anyway?  What other possibilities could it be?   
Oh and I did check all the lights on the extremely rare possibility  
that all 4 bright filaments were burned out, but both filaments on  
all the lights were good.  Somebody mentioned something about the  
turn signal switch being bad?  Was that only if the turn signals   
didn't work?  Anyway, I'm open to suggestions.  Thanks everybody.

	~Zack Morton~
	1974 4dr. LeBaron


-----------------  http://www.imperialclub.com  -----------------
This message was sent to you by the Imperial Mailing List. Please 
reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be 
shared with everyone. Private messages (and attachments) for the
Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm