Re: IML: 1960 fuel pump
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: IML: 1960 fuel pump



Yes Donn,

I think you have to turn the engine bit, the lob on the camshaft will
problably interfere with the lever at fuel pump while you are trying to
install it.
So try to rotate the crankshaft a little (and thus the camshaft too) and
see if it will fit then.

Good luck,

Robert
1960 Crown 4 door HT




Op Vr, 19 mei, 2006 10:09 am, schreef Donn Reese:
> I'm installing a new fuel pump from NAPA, their part number M3672.  Does
> anyone know if this is the correct one for a 1960?  Am having trouble
> getting it installed, lining up the bolts has been a headache.  Or
> perhaps I need to turn the engine a bit?
>
> Thanks,
>
>
> Donn Reese
> 1960 Imperial Custom 4dr Hardtop
>
>
>
> -----------------  http://www.imperialclub.com  -----------------
> This message was sent to you by the Imperial Mailing List. Please
> reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be shared
> with everyone. Private messages (and attachments) for the Administrators
> should be sent to webmaster@xxxxxxxxxxxxxxxx To UN-SUBSCRIBE, go to
> http://imperialclub.com/unsubscribe.htm
>
>
>




-----------------  http://www.imperialclub.com  -----------------
This message was sent to you by the Imperial Mailing List. Please 
reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be 
shared with everyone. Private messages (and attachments) for the
Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm



Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.