Re: IML: plates on the trans mount
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: IML: plates on the trans mount



Any chance those little plates on the trans mount were used as shims to change a driveshaft angle? The FSM shows shims on the center bearing support but I dont recall seeing any on my 62 or on the two 63's that I have owned. There is quite a bit of text in the service manual regarding the indexing and the anglularity of the prop shaft, maybe someone in the past had tried to correct a problem.

Mikey
62 Crown Coupe





----------------- http://www.imperialclub.com -----------------
This message was sent to you by the Imperial Mailing List. Please reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be shared with everyone. Private messages (and attachments) for the
Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm




Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.