Re: IML: 1962 transmission mount

[Markku Jaakkola <impcyclope2@xxxxxxxxx>]

Hi Paul!

 

Thanks for the reply,

the mount is ok, but there is some kind of a metal (shim?) plates that look like home made.

will post you a picture.

 

Markku 

RandalPark@xxxxxxx wrote:

There is suppose to be a thick piece of rubber vulcanized between those plates. It should not look "home made". If it does, it probably isn't any good, and isn't going to isolate the the power plant properly from the frame. This will result in excess noise and vibration, or a loose transmission bouncing around. The top plate should have two holes in it where is fastens to the transmission, and the bottom plate should have studs that fasten through the frame crossmember.

If the transmission is loose, you will feel the accelerator pulse up and down against your foot while driving through dips in the road. You will also feel the transmission "flop" from one side of the car to the other, when going around sharp curves. Later cars also had the tendency to do this, but due to the "cable controlled" throttle in these later models, the only noticible symptom is the "flopping" transmission. The problem is just as serious whether you can feel both sensations or not.

This problem is common to '62 through '65 Imperials.

Brand new mounts are available. I believe the name of the company is "King Mounts" or "Royal Mount" or maybe even "Imperial Mounts". They are listed in the Vendor's List on the OIC. I have purchased from them through the web and they are good.

You really should replace that mount. Also, check the two engine supports. They usually are broken or about to break as well, and available from the same vendor.

I am hoping that same vendor will someday make a replacement emergency brake cable for my '65 Imperial. I spoke to them about it once and they said that they were considering it.

Paul W.

In an email dated 22/5/2005 7:52:01 pm GMT Daylight time, Markku Jaakkola writes:

>Hi all!
>
>I was installing today my Imperials rebuilt transmission and noticed that there where some plates between transmission mount and transmission cross member, Does anyone have a parts book or pics of those plates 'cause they looked like self-made, not from the factory.
>Thanks.
>
>Markku
>
>
>------------------------------------------------------------------------
>Markku Jaakkola
>impcyclope@xxxxxxxxx
>Finland
>1962 Imperial 2d Ht Crown
>1957 Imperial 4d Ht Crown "single headlight"
>------------------------------------------------------------------------
>__________________________________________________
>Do You Yahoo!?
>Tired of spam?  Yahoo! Mail has the best spam protection around
>http://mail.yahoo.com
>


----------------- http://www.imperialclub.com -----------------
This message was sent to you by the Imperial Mailing List. Please
reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be
shared with everyone. Private messages (and attachments) for the
Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm

------------------------------------------------------------------------
Markku Jaakkola
impcyclope@xxxxxxxxx
Finland
1962 Imperial 2d Ht Crown
1957 Imperial 4d Ht Crown "single headlight"
------------------------------------------------------------------------

__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com