Re: IML: the hot starting problem,,,,,,again!!!!
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: IML: the hot starting problem,,,,,,again!!!!



If it doesn't have one of these, make one up out of ordinary foil & a piece of fiberglass which you can get at the Home Depot.
John
----- Original Message ----- From: "Ken W Stephenson" <kss37215@xxxxxxxx>
To: <mailing-list@xxxxxxxxxxxxxxxx>
Sent: Thursday, May 19, 2005 5:28 PM
Subject: Re: IML: the hot starting problem,,,,,,again!!!!



Excellent suggestion!  That foil backed fiber glass should never be
removed!
Ken
On Thu, 19 May 2005 17:04:45 -0700 (PDT) Rob Goodyear
<rob1964cc@xxxxxxxxx> writes:
I wonder if the hot starting problem occurs after the
odd factory installed insulation is removed from the
intake manifold area.  The lack of this added
installation would allow the gas in the carb area to
overheat(?)  Just a theory.  Any thoughts?

Rob Goodyear
1964 Crown Coupe
1/2 1964 Crown 4-dr
rob1964cc@xxxxxxxxx



__________________________________




----------------- http://www.imperialclub.com -----------------
This message was sent to you by the Imperial Mailing List. Please reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be shared with everyone. Private messages (and attachments) for the
Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm




Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.