Re: IML: car starts when it wants

[dardal@xxxxxxxxxxxxxxx]

Its possible that the timing is too advanced for the weak battery/starter.  Try
this.  Next time the car is somewhat warm and refuses to start, disconnect the
ignition (the central wire on the distributor).  If then the starter can turn
it over, that means the ignition is too advanced.  Retarding the timing is only
a temporary solution until you find the real problem (assuming that the 20 BTDC
is correct, it does sound a bit high).

D^2

Quoting bom tie <bomtie@xxxxxxxxxx>:

> 
> 
> 
> I have a 1978 NYB that has 50,000 miles or so on the clock. I have had the
> car for about 10 years and it has always needed a very healthy battery to
> start. I have not ran the car for the past 3 years, but now is the time.
> First changed ALL fluids and cleaned/sealed the tank. The car started with no
> problems. I started the car maybe 6 times over a 3 week time frame. Then I
> felt good about a test run. I start the car to turn the steering wheel as I
> push her to the door. I stop at the door turn the car off to bleed the brakes
> again just to be sure. 
> Bleed the brakes and then no start! 
> I attach a charger and try it from time to time. The engine was dragging as
> if out of time. I moved it a bit, but the dragging was erratic. The wire to
> the starter got hotter than I would have thought. The brown wire on the
> ballast was warm to the touch with the key "on" for only a few minutes.
> After 2 hours on the charger it started. I then set the timming to 20
> degrees- this is what the sticker on the car said. I drove the car for about
> 15 minutes (what a delight) and parked the car. I came back to it an hour
> later and NO START! Charged it overnight, started up still sounded like it
> was dragging.
> 
> 1.The battery is 950 Amp 6 months old, do I need a 1000?
> 2.I have 6.3v at the coil is that enough?
> 3.Is the starter going out?
> 4.Is 20 degrees where this needs to be? What if run 2nd grade? Or just adjust
> it to where I dont ping going up a hill?
> 5. Charging system checks out
> 6. Computer mounted on breather, can they halfway go out?
> 7. Carb OR VAC issues???
> I dont want to just start replacing parts,
> Charles
> 
> _______________________________________________
> Join Excite! - http://www.excite.com
> The most personalized portal on the Web!
> 
> 
> -----------------  http://www.imperialclub.com  -----------------
> This message was sent to you by the Imperial Mailing List. Please 
> reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be 
> shared with everyone. Private messages (and attachments) for the
> Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
> To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm
> 
> 





-----------------  http://www.imperialclub.com  -----------------
This message was sent to you by the Imperial Mailing List. Please 
reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be 
shared with everyone. Private messages (and attachments) for the
Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm