RE: IML: Imperial wheel bolt patterns

since we are talking about the imp's wheels. I would like to firnd a like new set of factory wheels for my 59 crown.. does anyone make these wheels anymore,?
also any one have 1 0r 2 good extra hubcaps for sale?, never know when I might need one.
Rob McCall <Rob_Mopar@xxxxxxxxxxx> wrote:

Ted,

The AMC wheels are 4.5? bolt pattern. Same as most of the Mopar line, except for the small 4? pattern on some A-bodies, and the 5? Imperials. I measured my ?67 and it is the 5? pattern. I don?t know if the ?74-75 cars used the 5? pattern. The later J-body ?81-83 should have the 4.5? bolt pattern.

The 14? wheels might be good to use while a car is in the body shop too.

Rob McCall

?67 LeBaron

-----Original Message-----
From: mailing-list-owner@xxxxxxxxxxxxxxxx [mailto:mailing-list-owner@xxxxxxxxxxxxxxxx] On Behalf Of Cebuisle2@xxxxxxx
Sent: Sunday, January 23, 2005 7:24 PM
To: mailing-list@xxxxxxxxxxxxxxxx
Subject: Re: IML: Imperial wheel bolt patterns

Hello-

I have found there wheels from an AMC Pacer will fit the bolt hole pattern on some Imps, don't remember if pre or post fifties models. I think they were post 60's Imps. Of course the AMC wheels are fourteen inch instead of the required 15, but these wheels will serve to move your car around the lot if needed. Or down the road if you don';t mind a lower stance and incorrect speedometer reading.

TED