Has anyone put that kind of kit to car?
I think biggest problem is those back seat windows, because of those movements.
That kit number 3, is not possible to use with smaller windows i think.
First to might be possible to install to all four windows, but i dont like to leave original crank shafts in place.
Edited by MSS73 2022-12-18 6:33 PM
(01.jpg) (02.jpg) (03.jpg)
01.jpg (166KB - 17 downloads)
02.jpg (147KB - 16 downloads)
03.jpg (105KB - 20 downloads)
Location: Ponder, TX
|I installed a '56 Plymouth front set with a kit very similar to picture 3 and it was an easy install, but I think it would be difficult to adapt this style for rear windows that rotate like those in my 2-door hardtop. For those that use the stock crank and linkage, you could probably shorten the shaft and put some kind of trim |
over the existing door panel hole and locate the new switch somewhere else.