The Forward Look Network
The Forward Look Network
Search | Statistics | User Listing Forums | Chat | eBay | Calendars | Albums | Skins | Language
You are logged in as a guest. ( logon | register )

Fuel sending unit ground
Jump to page : 1
Now viewing page 1 [50 messages per page]
View previous thread :: View next thread
   Forward Look Technical Discussions -> General Technical Discussion and TroubleshootingMessage format
 
61lemon
Posted 2022-01-25 8:14 PM (#618771)
Subject: Fuel sending unit ground


New User

Posts: 4

I am stumped. I Peg the wire and gas gauge goes to full. (Clip to ground from the hardwire)
I pulled out the fuel sending unit, and tested it on the bench as well as plugged in to the hardwire and the gas gauge works. When I have it in, it’s not working. Is it the ground even though I have that black clip?
Do I need a stronger ground?
Top of the page Bottom of the page
Powerflite
Posted 2022-01-25 9:19 PM (#618774 - in reply to #618771)
Subject: Re: Fuel sending unit ground



Expert 5K+

Posts: 9604
500020002000500100
Location: So. Cal
Sounds like it. Try using a test clip from the outlet to a known good ground, and see if that solves the problem. Those factory clips aren't a great solution. I have used a hose clamp to clamp a wire to the sender outlet and then screw that into the body when I have trouble with it. With the sender out, you might be able to solder a wire to it as well, if you have a pen torch.

There is also a chance that the sender has issues with moving side-to-side. Sometimes they register only when slightly pushed on one side, and so when it goes in the tank, you don't get that and it doesn't work.
Top of the page Bottom of the page
Jump to page : 1
Now viewing page 1 [50 messages per page]
Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

* * * This site contains affiliate links for which we may be compensated * * *


(Delete all cookies set by this site)