|
|
Expert
Posts: 2206
 
Location: Muskego, WI | I will begin parting this car ASAP. I will be keeping a few items for my 1960 Plymouth wagon, the rest is up for grabs. Slant 6, 3 speed on the column. Front disc brake conversion, car runs drives and stops. Very nice grill. Good hood, trunk lid and doors. Fenders have rust in bottom corners, but overall very nice. Solid trunk floor. Rear defrost. Chrome Fury tail lights. Pictures in the link below.
http://www.forwardlook.net/forums/forums/thread-view.asp?tid=72949&... |
|
| |
|
Elite Veteran
Posts: 784
 
| I would be interested in grille
Plymouth emblem on rear section.
If you happen to have dash rear defogger bezel?
Ignition key with bezel,door locks glove box lock and trunk lock.
I sure there's many more things I can use. |
|
| |
|
Elite Veteran
Posts: 784
| I would be interested in chrome tailights also |
|
| |
|
Expert
Posts: 2206
Location: Muskego, WI | PM me with a dollar amount offer for each item and we'll go from there. |
|
| |
|
Expert
Posts: 2206
Location: Muskego, WI | walk around of the car:
https://www.youtube.com/watch?v=a3Ilp0Caj98
|
|
| |
|
Elite Veteran
Posts: 784
| Interesting idea on parting out cars with video. I will have to try that sometime |
|
| |
|
Expert
Posts: 2206
Location: Muskego, WI | This car was completely disassembled yesterday other than any suspension parts. For those of you that have already contacted me by PM or email, I will begin responding tonight with pictures. Everyone else, let me know what you need. |
|
| |
|
Exner Expert 10K+
Posts: 10033
Location: So. Cal | Is that a 2bbl carburetor? |
|
| |
|
Expert
Posts: 2206
Location: Muskego, WI | Hear is a list of MOST parts with prices WITHOUT shipping:
Grill, very nice, but screw through Plymouth emblem - $150
Rear quarter stainless, pair - $100
Steering wheel, 1958 Plymouth, no horn button - $50
Running slant six, minus starter, alternator and distributor - $150
3 speed manual trans, rolls smooth, no noises when driven - $75
Driver fender, very nice other than behind head lights and bottom behind wheel well - $75
Pass fender, very nice other than behind head lights and bottom behind wheel well - $75
Rear windshield - $100
Rear windshield stainless trim, vey straight - $100
Rear defrost setup (no original dash switch), works - $100
Driver door, very nice, with glass and regulator - $150
Pass door, very nice, with glass and regulator - $150
Gas tank with cap and sending unit, very nice - $150
Driver rear quarter glass and manual regulator - $50
Pass rear quarter glass and manual regulator - $50
Hood, outside skin is very straight, but rusted out on inside near pass hinge and front inside edge - $50
Trunk lid, outside skin is very straight, but rusted out on inside edge - $50
Driver front panel below fender behind bumper, solid and straight - $25
Passenger front panel below fender behind bumper, solid and straight - $25
Vertical front core support brace - $25
Horizontal piece that joins the top front fenders and hood latches to, slight bend but can be straightened - $25
Center grill brace - $15
Very nice chrome tail light housings - $35 each
Rolling chassis and body shell with VIN and WI title in my name. No brakes, but will leave front steering linkage. - $150
All prices are or best offer, looking to move this stuff fast to clear out my garage. I haven't listed some stuff yet, if you don't see it just ask. If it doesn't sell it will most like get scrapped. Send me a PM with what you want and provide a cell number I can text pictures to or an email address so you can see condition. I will posting this on FB as soon as I can as well. Located in Milwaukee, WI area.
 (Plymouth Stripped 1.jpg)
 (Plymouth Stripped 2.jpg)
 (Plymouth Stripped 3.jpg)
 (Plymouth Stripped 4.jpg)
Attachments
----------------
 Plymouth Stripped 1.jpg (113KB - 352 downloads)
Plymouth Stripped 2.jpg (105KB - 345 downloads)
Plymouth Stripped 3.jpg (115KB - 348 downloads)
Plymouth Stripped 4.jpg (91KB - 343 downloads)
|
|
| |
|
Expert
Posts: 2206
Location: Muskego, WI | UPDATE, MANY OF THE ITEMS HAVE SALES PENDING
Hear is a list of MOST parts with prices WITHOUT shipping:
Grill, very nice, but screw through Plymouth emblem - $150 PENDING
Rear quarter stainless, pair - $100 PENDING
Steering wheel, 1958 Plymouth, no horn button - $50 PENDING
Running slant six, minus starter, alternator and distributor - $150
3 speed manual trans, rolls smooth, no noises when driven - $75
Driver fender, very nice other than behind head lights and bottom behind wheel well - $75 PENDING
Pass fender, very nice other than behind head lights and bottom behind wheel well - $75 PENDING
Rear windshield - $100
Rear windshield stainless trim, vey straight - $100
Rear defrost setup (no original dash switch), works - $100
Driver door, very nice, with glass and regulator - $150 PENDING
Pass door, very nice, with glass and regulator - $150 PENDING
Gas tank with cap and sending unit, very nice - $150
Driver rear quarter glass and manual regulator - $50 PENDING
Pass rear quarter glass and manual regulator - $50 PENDING
Hood, outside skin is very straight, but rusted out on inside near pass hinge and front inside edge - $50 PENDING
Trunk lid, outside skin is very straight, but rusted out on inside edge - $50
Driver front panel below fender behind bumper, solid and straight - $25 PENDING
Passenger front panel below fender behind bumper, solid and straight - $25 PENDING
Vertical front core support brace - $25 PENDING
Horizontal piece that joins the top front fenders and hood latches to, slight bend but can be straightened - $25 PENDING
Center grill brace - $15 PENDING
Very nice chrome tail light housings - $35 each PENDING
Rolling chassis and body shell with VIN and WI title in my name. No brakes, but will leave front steering linkage. - $150
All prices are or best offer, looking to move this stuff fast to clear out my garage. I haven't listed some stuff yet, if you don't see it just ask. If it doesn't sell it will most like get scrapped. Send me a PM with what you want and provide a cell number I can text pictures to or an email address so you can see condition. I will posting this on FB as soon as I can as well. Located in Milwaukee, WI area. |
|
| |
|
Expert
Posts: 2206
Location: Muskego, WI | UPDATE, removing items that have been paid for and adding items not previously listed:
Grill, very nice, but screw through Plymouth emblem - $150 PENDING
Rear quarter stainless, pair - $100 PENDING
Running slant six, minus starter, alternator and distributor - $150
3 speed manual trans, rolls smooth, no noises when driven - $75 PENDING
Driver fender, very nice other than behind head lights and bottom behind wheel well - $75 PENDING
Pass fender, very nice other than behind head lights and bottom behind wheel well - $75 PENDING
Rear windshield - $100
Rear windshield stainless trim, vey straight - $100
Driver door, very nice, with glass and regulator - $150 PENDING
Pass door, very nice, with glass and regulator - $150 PENDING
Gas tank with cap and sending unit, very nice - $150
Driver rear quarter glass and manual regulator - $50 PENDING
Pass rear quarter glass and manual regulator - $50 PENDING
Hood, outside skin is very straight, but rusted out on inside near pass hinge and front inside edge - $50 PENDING
Trunk lid, outside skin is very straight, but rusted out on inside edge - $50
Driver front panel below fender behind bumper, solid and straight - $25 PENDING
Passenger front panel below fender behind bumper, solid and straight - $25 PENDING
Vertical front core support brace - $25 PENDING
Horizontal piece that joins the top front fenders and hood latches to, slight bend but can be straightened - $25 PENDING
Center grill brace - $15 PENDING
Very nice chrome tail light housings - $35 each PENDING
Front firewall and cowl with VIN and WI title in my name, transferable to you - $100
Front sub-frame with torsion bar suspension and steering linkage, no brakes (straight, but will need a few rust patches) - $100
Trunk hinges - $25
Trunk torsion bars - $25
Reverse light lenses - $10
Front bumper brackets - $20
|
|
| |
|
Expert
Posts: 2206
Location: Muskego, WI | UPDATE, removing items that have been paid for and adding items not previously listed:
The front sub frame has been separated, the empty shell will be scrapped this Saturday, April 24th, so if you need something speak up now.
Grill, very nice, but screw through Plymouth emblem - $150 PENDING
Running slant six, minus starter, alternator and distributor - $150
3 speed manual trans, rolls smooth, no noises when driven - $75 PENDING
Driver fender, very nice other than behind head lights and bottom behind wheel well - $75 PENDING
Pass fender, very nice other than behind head lights and bottom behind wheel well - $75 PENDING
Rear windshield - $100
Rear windshield stainless trim, vey straight - $100
Driver door, very nice, with glass and regulator - $150 PENDING
Pass door, very nice, with glass and regulator - $150 PENDING
Gas tank with cap and sending unit, very nice - $150
Driver rear quarter glass and manual regulator - $50 PENDING
Pass rear quarter glass and manual regulator - $50 PENDING
Hood, outside skin is very straight, but rusted out on inside near pass hinge and front inside edge - $50 PENDING
Trunk lid, outside skin is very straight, but rusted out on inside edge - $50
Driver front panel below fender behind bumper, solid and straight - $25 PENDING
Passenger front panel below fender behind bumper, solid and straight - $25 PENDING
Vertical front core support brace - $25 PENDING
Horizontal piece that joins the top front fenders and hood latches to, slight bend but can be straightened - $25 PENDING
Center grill brace - $15 PENDING
Very nice chrome tail light housings - $35 each PENDING
Front firewall and cowl with VIN and WI title in my name, transferable to you - $100
Front sub-frame with torsion bar suspension and steering linkage, no brakes (straight, but will need a few rust patches) - $100
Trunk hinges - $25
Trunk torsion bars - $25
Reverse light lenses - $10
Front bumper brackets - $20
 (sub frame 1.jpg)
 (sub frame 2.jpg)
Attachments
----------------
sub frame 1.jpg (101KB - 336 downloads)
sub frame 2.jpg (136KB - 343 downloads)
|
|
| |
|
Expert
Posts: 2206
Location: Muskego, WI | UPDATE, removing items that have been paid for and adding items not previously listed:
Running slant six, minus starter, alternator and distributor - $150
Rear windshield - $100
Rear windshield stainless trim, vey straight - $100
Gas tank with cap and sending unit, very nice - $150
Hood, outside skin is very straight, but rusted out on inside near pass hinge and front inside edge - $50
Front sub-frame with torsion bar suspension and steering linkage, no brakes (straight, but will need a few rust patches) - $100
Trunk hinges - $25
Trunk torsion bars - $25
Rear seat bench and back rest - $50 |
|
| |
|
Expert
Posts: 2206
Location: Muskego, WI | UPDATE, removing items that have been paid for and adding items not previously listed:
Not much left and I have all my money out of this car and the parts I wanted for my wagon. I'm counting this a win for me at this point, anything not sold will be scrapped soon so step up with an offer.
Running slant six, minus starter, alternator and distributor - $150
OR Running slant six with starter, alternator and distributor - $300 (distributor has Pertronix conversion, alternator and starter are new)
Rear windshield - $100
Gas tank with cap and sending unit, very nice - $150
Hood, outside skin is very straight, but rusted out on inside near pass hinge and front inside edge - $50
Trunk Hinges with torsion bars - $30
Front sub frame, complete minus brakes - $100
If the sub frame get parted:
Torsion bars - $50 each
Spindle - $30 each
Suspension Arm, upper - $25 each
Suspension Arm, lower - $25 each
Strut rod - $15 each
Steering arm - $20 each
Idler arm - $20
Center link - $50
Tie Rods - $20 each
Thank you to those of you who have purchased parts. |
|
| |
|
Expert
Posts: 2206
Location: Muskego, WI | UPDATE:
Down to just the front sub frame and parts:
Front sub frame, bare - $75
Torsion bars - $50 each
Spindle - $30 each
Suspension Arm, upper - $25 each
Suspension Arm, lower - $25 each
Strut rod - $15 each
Steering arm - $20 each
Idler arm - $20
Center link - $50
Tie Rods - $20 each |
|
| |
|
Veteran
Posts: 118
Location: Maryland | Jon,
I know this is an older post, but was wondering if you have anything left of this thing? I wouldnt mind having the push-button/auto trans delete/block off, and possibly all 4 of the control arms.
Thanks....
P.S. I'll try sending you a PM as well.... |
|
| |
1961 Plymouth Savoy 2 Door Sedan
