The Forward Look Network | ||
| ||
Power antenna switch location Jump to page : 1 Now viewing page 1 [50 messages per page] | View previous thread :: View next thread |
Forward Look Technical Discussions -> Body, Glass, Interior and Trim | Message format |
macedon |
| ||
Elite Veteran Posts: 963 Location: San Antonio, TX | I was looking at cleaning up some wiring in my dash on the 57 De Soto sedan. There had been some sort of "issue" sometime in its past and a few wires had obviously gotten hot. They had also installed a bypass switch for the A/C. Anyhow long story short I'm trying to replace bad wires, and put things back right. As close as I can anyhow. My question... does anyone have the proper location for the power antenna switch. Mine was just hanging loose below the dash. I looked around and couldn't find two mounting holes spaced for it. It works and the wiring looks original. Just not mounted properly. Ideas? (antenna.JPG) Attachments ---------------- antenna.JPG (49KB - 172 downloads) | ||
miquelonbrad |
| ||
Expert Posts: 1737 Location: Hay Lakes, Alberta, Canada | AS far as I know, that isn't an original switch. They used a toggle style switch. The Chryslers had it mounted on the dash, below the transmission push buttons. I'm not sure where the switch may have been mounted on the DeSoto. I looked in the parts manual, and they only list one type of switch... | ||
macedon |
| ||
Elite Veteran Posts: 963 Location: San Antonio, TX | Here's a few more pictures. I'm fairly certain this is factory. Or someone spent a LOT of trouble making it look so. (pw1.JPG) (pw2.JPG) (pw3.JPG) (pw4.JPG) Attachments ---------------- pw1.JPG (193KB - 163 downloads) pw2.JPG (97KB - 169 downloads) pw3.JPG (121KB - 159 downloads) pw4.JPG (156KB - 176 downloads) | ||
Rebels-59 |
| ||
Board Moderator & Exner Expert 10K+ Location: .Norfolk..Mafia.. ,England UK | miquelonbrad - 2017-04-26 6:32 AM AS far as I know, that isn't an original switch. They used a toggle style switch. The Chryslers had it mounted on the dash, below the transmission push buttons. I'm not sure where the switch may have been mounted on the DeSoto. I looked in the parts manual, and they only list one type of switch... The Toggle switch mounted below the Pushbuttons is usually for the Drivers Fender Mirror remote operation.. . | ||
Greg P. |
| ||
Elite Veteran Posts: 769 Location: Oley, PA | Looks like the switch from a mid sixties corvette. http://www.ebay.com/itm/1965-1966-Corvette-Power-Antenna-Switch-/38... (antenna switch2.jpg) Attachments ---------------- antenna switch2.jpg (30KB - 156 downloads) | ||
macedon |
| ||
Elite Veteran Posts: 963 Location: San Antonio, TX | So the wiring diagram from the service manual shows a power antenna. Although the diagram calls for Brown-Red-Black and my car is White-Red-Black. No one I've asked including Ed has ever seen one. So who knows? Guess that makes my FireFlite just that much more special. Apparently the proper location for that power antenna switch is wherever I so decide Edited by macedon 2017-06-15 10:05 AM (wd.JPG) Attachments ---------------- wd.JPG (210KB - 163 downloads) | ||
miquelonbrad |
| ||
Expert Posts: 1737 Location: Hay Lakes, Alberta, Canada | Well...I'll buy the same switch as you have, and place mine in the same spot you decide to. Since we both will look the same, we'll set the standard for "correct" factory installation. | ||
Powerflite |
| ||
Expert 5K+ Posts: 9648 Location: So. Cal | My '58 New Yorker came with that option. I will take a look tonight and see what I can find out. | ||
LD3 Greg |
| ||
Expert Posts: 1906 Location: Ontario, Canada | Originally, it was a simple toggle switch. The wiring connector shown is definitely not original for a 57/58! Greg (image.jpg) Attachments ---------------- image.jpg (126KB - 150 downloads) | ||
Powerflite |
| ||
Expert 5K+ Posts: 9648 Location: So. Cal | This is the antenna switch in my '58 New Yorker. The toggle switch doesn't look original and the wires have been spliced in at some point. I am not sure if this is the original location for it by the radio, or if it was on the far left side of the dash. I have 2 extra holes over there as well. (58NYAntennaSwitch.jpg) (58NYExtra Holes.jpg) Attachments ---------------- 58NYAntennaSwitch.jpg (97KB - 142 downloads) 58NYExtra Holes.jpg (99KB - 156 downloads) | ||
miquelonbrad |
| ||
Expert Posts: 1737 Location: Hay Lakes, Alberta, Canada | I have a '57 Chrysler Canuck Windsor parts car, with power antenna, and it has a toggle switch mounted in the upper small hole, just like in your picture above. So, must be the right spot! The toggle switch has a flat handle on it, instead of round. | ||
Powerflite |
| ||
Expert 5K+ Posts: 9648 Location: So. Cal | Sounds like we have a consensus. Please post up a pic of your switch when you get a chance. | ||
miquelonbrad |
| ||
Expert Posts: 1737 Location: Hay Lakes, Alberta, Canada | So, I finally found where I stashed the switch/wiring harness, when I removed it from the car. And I apologize, as my memory was wrong. The toggle switch does have a round handle, not flat as I thought. (IMG_1725sm.jpg) (IMG_1726sm.jpg) (IMG_1727sm.jpg) (IMG_1728sm.jpg) Attachments ---------------- IMG_1725sm.jpg (159KB - 159 downloads) IMG_1726sm.jpg (94KB - 161 downloads) IMG_1727sm.jpg (132KB - 139 downloads) IMG_1728sm.jpg (127KB - 158 downloads) | ||
LD3 Greg |
| ||
Expert Posts: 1906 Location: Ontario, Canada | miquelonbrad - 2017-06-25 4:58 PM So, I finally found where I stashed the switch/wiring harness, when I removed it from the car. And I apologize, as my memory was wrong. The toggle switch does have a round handle, not flat as I thought. That's original. Thanks Brad. BTW, the toggle is a momentary top and bottom switch and the off is in the middle. Greg | ||
Powerflite |
| ||
Expert 5K+ Posts: 9648 Location: So. Cal | Neat. Thanks for taking the time to post that Brad. | ||
macedon |
| ||
Elite Veteran Posts: 963 Location: San Antonio, TX | I've got a comprehensive stack of paperwork on this 57 De Soto. Original invoice, original owner's service certificate, etc., etc. Plus all the receipts for tires, batteries, servicing on and on. No mention of the power antenna anywhere. Original? Perhaps not. The part that intrigues me is the wiring and connectors are consistent with all the rest of the factory wiring. The power lead was plugged into the buss on the back of the temp gauge just like the wiring diagram calls for and it has the very same connector as all the rest. If it wasn't installed by the factory or the dealer somebody sure went to a lot of trouble to make it look like it was. (pw1.JPG) Attachments ---------------- pw1.JPG (193KB - 157 downloads) | ||
Powerflite |
| ||
Expert 5K+ Posts: 9648 Location: So. Cal | Brad's switch is very similar to the '57 Imperial defroster switch too. Same style, just not momentary. (57ImpDefrosterSwitch.jpg) Attachments ---------------- 57ImpDefrosterSwitch.jpg (163KB - 154 downloads) | ||
Powerflite |
| ||
Expert 5K+ Posts: 9648 Location: So. Cal | This 300D with power antenna has the switch in the lower hole on the dash. I don't know what the other switch is for, but it is obviously not OEM. (300D Electric Antenna.jpg) Attachments ---------------- 300D Electric Antenna.jpg (169KB - 165 downloads) | ||
miquelonbrad |
| ||
Expert Posts: 1737 Location: Hay Lakes, Alberta, Canada | macedon - 2017-06-26 8:51 AM I've got a comprehensive stack of paperwork on this 57 De Soto. Original invoice, original owner's service certificate, etc., etc. Plus all the receipts for tires, batteries, servicing on and on. No mention of the power antenna anywhere. Original? Perhaps not. The part that intrigues me is the wiring and connectors are consistent with all the rest of the factory wiring. The power lead was plugged into the buss on the back of the temp gauge just like the wiring diagram calls for and it has the very same connector as all the rest. If it wasn't installed by the factory or the dealer somebody sure went to a lot of trouble to make it look like it was. A couple of options: the wiring may be original, but the switch was replaced at some time, due to failure. Or, it may be a dealer installation of a non-oem kit. Your rear-mounted antenna doesn't appear to look the same as the front fender-mounted ones Chrysler used. But, maybe Chrysler used two different ones, due to the differences in how they are mounted? Due to the rarity of this option, information and pictures are hard to come by... | ||
Jump to page : 1 Now viewing page 1 [50 messages per page] |
Search this forum Printer friendly version E-mail a link to this thread |
(Delete all cookies set by this site) | |