|
|
Extreme Veteran
Posts: 375
Location: milano, italy | Hello
is there any source for some convertible top weatherstrip? Need the header panel and side rails w/s. Any idea? |
|
|
|
Expert
Posts: 4589
Location: Northern New Jersey | Gary Goes should have what you need. |
|
|
|
Extreme Veteran
Posts: 375
Location: milano, italy | still looking for these parts. Had sent a letter with a check to Goers one year ago, with a list of few parts I was needing, but no reply on anything, no parts either. Also, looking for door panels for the same car. Don't want to deal with SMS once more, after waiting interior matherial for the car for over a year. I haerd someone in Sweden..any help? |
|
|
|
Expert
Posts: 1737
Location: Hay Lakes, Alberta, Canada | Gary Goers is not in good health, and is closing down his business. As for SMS, I believe that they are the only ones doing any of the interior cloths and embossed vinyl materials. If you have the cloth and vinyl, you can probably find a local upholstery shop to manufacture the door panels. |
|
|
|
Extreme Veteran
Posts: 375
Location: milano, italy | Brad, , I already have sourced all interior stuff from SMS, and have just ordered the door panels from them. I know wait will be longer than anticipated, but have old stuff that can work for the moment. They quoted 775 $ for the interior panels, which is not crazy. Thay told me late january, but am pretty sure they will be delayed. Found some roof rail w/s from Bernbaum, but have no idea if they fit correctly or if they are wrong. Any feedback on them? |
|
|
|
Extreme Veteran
Posts: 375
Location: milano, italy | Got the top frame weatherstrip, and while profile is accurate, nothing else is correct. Holes are spaced wrong and lenght of rubber pieces is wrong. Original w/s on car are six pieces, while Bernbaum stuff is 8 pieces. Four are about the correct length, the front and rear pieces can be cut to fit. But the other four pieces are too short to be used, unless they are glued together. Really don't understand why they couldn't be cut correctly. What is the sense and the reason of getting a fairly correct profile...but wrong length and wrong hole spacing. |
|
|