|
|
Expert
Posts: 3802
Location: NorCal |
I asked this a long time ago and never got an answer.
I need the length measurement of the engine dipstick and the dimension of the dipstick tube from the block up to the top end of the tube. |
|
|
|
Elite Veteran
Posts: 1120
Location: STL, MO | I am going to machine shop tomorrow to finish my engine (mill intake) i can measure what I fabbed for my dipstick tube and stick however it's not stock but the pan is if this would help |
|
|
|
Expert
Posts: 3967
Location: DFW, TX | I'll check mine tonight. |
|
|
|
Expert
Posts: 3802
Location: NorCal |
Did you get a chance to measure them? |
|
|
|
Elite Veteran
Posts: 1120
Location: STL, MO | Sorry John I didnt make it to machine shop last week, but am going tommorow |
|
|
|
Expert
Posts: 3967
Location: DFW, TX | Forgot all about it John. Dang. I will do it tonight. Apologies for the delay. |
|
|
|
Elite Veteran
Posts: 1120
Location: STL, MO | mine is custom fabbed and leans over the towards the leftside valvecover 11 inches showing, 1/2 inch in the block,I gotta go back tommorow and drill off my wirecover anchors on valvecovers, and I'll get the rest of it then. |
|
|
|
Expert
Posts: 2321
Location: Eastern Iowa | Just checked mine on a 300D engine and have tube length of 9-7/8" from the block
The dipstick is overall length of 26-5/16" with 23-3/8 from the top of the cap to bottom of stick.
Dave S. |
|
|
|
Expert
Posts: 3802
Location: NorCal |
Thanks, Dave, that's the info I needed. |
|
|