Tightening reference for early-hemi/poly
brdtee
Posted
2018-01-12 12:34 AM (#556085)
Subject:
Tightening reference for early-hemi/poly
Veteran
Posts: 258
Location: Pieksamaki, Finland, Europe
I found these tightening reference values from the shop manual but what might be the correct values for..
1
) main bearing bolts
2
) crankshaft bolts
And is there something else to be notified while assembling a 354 poly?
Edited by brdtee 2018-01-12 12:36 AM
(4994911e-2305-4435-ab5d-7815031b7e7d.jpg)
Attachments
----------------
4994911e-2305-4435-ab5d-7815031b7e7d.jpg
(107KB - 117 downloads)
Leadfoot1000
Posted
2018-01-12 12:47 AM (#556086 - in reply to #556085)
Subject:
RE: Tightening reference for early-hemi/poly
Veteran
Posts: 241
Location: Southern CA
I got these specs from Hot Hemi Heads website.
Attachments
----------------
FC813C19-36CF-4377-82E3-74DAF70E9C85.jpeg
(91KB - 110 downloads)
56D500boy
Posted
2018-01-12 12:55 AM (#556087 - in reply to #556086)
Subject:
RE: Tightening reference for early-hemi/poly
Expert 5K+
Posts: 9899
Location: Lower Mainland BC
Leadfoot1000 - 2018-01-12 12:47 AM
I got these specs from Hot Hemi Heads website.
Your upload failed because of the "jpeg"
(has to be "jpg", no "e"
).
I've copied it, saved it as a jpg and uploaded it
(again, this time it works
). Thanks for the original posting.
Edited by 56D500boy 2018-01-12 12:59 AM
(EarlyHemiTorqueSpecsFromLeadFoot1000.jpg)
Attachments
----------------
EarlyHemiTorqueSpecsFromLeadFoot1000.jpg
(55KB - 100 downloads)
Tightening reference for early-hemi/poly Tightening reference for early-hemi/poly
