Vote for The Forward Look Network on the Mopar Top 100 Sites 

Re: 1958 plymouth alignment ?

From: Neil Vedder
Remote Name:
Date: August 27, 2003
Time: 01:46:00


Jeez, Eric, I can't believe that no one has responded to your message (which I'm just cruizin-by, discovering it, tonite). You probably know, by now, that there are 'dedicated' shims that are used to adjust the caster, & indirectly, the camber. Toe-in is adjusted separately. You want to try to acheive as much caster (for-self-centering-effect) as possible; my shop achieved 1.5+ degrees caster, before the camber adjustment began to be affected by the caster- adjustment. I just tried to find my archival- record on my 57 Dodge's front end alignment, but couldn't find it. If you check with this Discussion Board's archives, you might find earlier discussion on my front end geometry- recommendation. Neil Vedder


Last changed: July 19, 2018