|
|
| Vote for The Forward Look Network on the Mopar Top 100 Sites |
From: Mal from Australia
Email: maljulie@tpg.com.au
Remote Name: 202.7.190.197
Date: July 11, 2003
Please help me. I have just spent a few invigorating hours trying to get a new rubber dust boot through the trunnion on my '63 valiant prop shaft. The (official) book says it can be done, they even show pictures of "working the boot through the trunnion". So why has mine decided not to come out the other side? I oiled it up and I pull as hard as I dare on the small part peeking through but it wont budge. The other end is deep within the trunnion, past the pin and impossible to get to. The boot cost $60 and I am just about ready to burn it out! Any suggestions would be gratefully accepted. Yours with numb thumbs Mal
