|
|
| Vote for The Forward Look Network on the Mopar Top 100 Sites |
From: Jessica Hendricks
Email: Mopargirlie_63@yahoo.com
Remote Name: 4.17.81.221
Date: November 03, 2002
OOps...i forgot to mention: You'll need to fill the bag at least an inch thick w/ the shot (leave some room for the shot to move around a lil bit) and lay it directly beneath the spot you are goingn to hammer. Make sure when you lay it down its about 10 inches in diameter. when you hammer down on the line, the shot should move clear on either side to form the groove and to support the metal so that it is not flat against the table.-- sorry for not being more clear on this earlier :P Jessica Hendricks
