|
|
| Vote for The Forward Look Network on the Mopar Top 100 Sites |
From: Eric Carlson
Email: sk8bored@qwest.net
Date: February 15, 2001
Daven...Thanks so much for the info and all the info you, and everyone has on here! Talking to local Mopar guys has left me lost!!! But, this discussion group is the best!! Great, the '68 will work and it's good too. I measured the pads for the leafs and the '68 Chrysler is 1/2 inch wider....does this matter? Do I need a big block '62-64 valve body, or will any tranny work? Is this valve body swap easy for the average hands? I would like to do the front spindles swap too, where do you measure the 10.5? Thanks again...
