|
|
| Vote for The Forward Look Network on the Mopar Top 100 Sites |
From: Hank Dozier
Email: dozier <at> aol.com
Remote Name: 64.12.96.167
Date: September 27, 2003
Actually, this wire is left over from the sandcore layup process used to make the heads. The wire was used to hold the cores tightly together so the pour would not seperate them. Then the sand is tumbled out of the raw casting before the machining that finishes the head. The wire stays behind, however, since it is sometimes trapped by the iron. Doesn't hurt anything.
