|
|
| Vote for The Forward Look Network on the Mopar Top 100 Sites |
From: lars
Email: HAH!@monkeys.net
Remote Name: 205.188.208.75
Date: August 14, 2003
On one of your crawls below Christine, look at the bolts holding the rear motor mount(s). In fact have two wrenches handy, think they are 9/16 or 5/8, and check for tightness. You could find one does not even have a correspsonding nut on the end. Been ther done that replaced the whole mount which had allowed the whole back end of engine/trans to slide about 3/4" out of true centerline.
