|
|
| Vote for The Forward Look Network on the Mopar Top 100 Sites |
From: Jeffc
Email: jeffc@pcez.com
Remote Name: 209.102.127.227
Date: May 15, 2003
If you can't get the hesitation out with the air mix screws, then you need to step the acceleralor pump plunger up one set of holes, it's the rod that comes up out of the top of the bowl with a piece of linkage, should have a set of holes on the rod and were the linkage goes on the throttel body linkage, adjust there or at both points to get the right combo, it may take a few try's, but you should be able to get most or all of the flat spot out...
