|
|
| Vote for The Forward Look Network on the Mopar Top 100 Sites |
From: Mike B
Email: mikeb@accu-comm.com
Remote Name: 206.63.254.41
Date: February 19, 2003
Guy, Take your sender unit and clean off the exterior face of the round plate part. There should be a stamped part number there. Sand blasting works best. This is the number you need. My '61 ended up being a part number not mentioned in the parts book. It measures 66 ohms empty and 10 ohms full, and I don't know if it was the same in '60 or not, but I'd bet it was. I have not found a source yet for mine. Hope this is some help.
